2016 July | CivilLaser Blog

Monthly Archives: July 2016

July 8, 2016 All Posts, Civil Laser, Instructions

Analog Modulation VS TTL Modulation

The default modulation is Analog. (TTL modulation can be customized. )

Analog modulation:

1. Use Analog modulation can adjust the laser output power.
2. We use 0~5V voltage as the analog single.

TTL modulation:

1. High voltage signal turn on the laser power, low voltage signal turn off the laser power.
2. The high voltage is about 3V, The low voltage is about 1V.

- Recent Posts
- Comments
- C+L Band 26dBm 400mW Erbium-doped Fiber Amplifier
  
  3:10 AM By MeiLing Chen
  With the rapid development of information technology, optical fiber communication has become the cornerstone of modern communication networks. In optical fiber communication systems, erbium-doped fiber amplifiers Read More »
- 1550nm 10KW Peak Power Pulse Nanosecond Fiber Laser
  
  6:29 AM By MeiLing Chen
  Today our laboratory introduces a 1550nm 10kW nanosecond pulse fiber laser. It is a modular design, the size is 100x100x30 mm. This nanosecond laser module uses an Read More »
- 40dBm 10W High Power Erbium-doped PM Fiber Amplifier
  
  6:10 AM By MeiLing Chen
  The one in the video is a benchtop 40dBm erbium-doped fiber amplifier. The input and output fibers of the PM amplifier are polarization maintaining fiber PM1550 and Read More »
- 532nm 7W High Power Diode Pumped Laser
  
  1:24 AM By MeiLing Chen
  This time it is a 532nm green DPSS laser commonly used in laboratories. Its output power can reach 7000mW. A heat dissipation module is added to the Read More »
- 1550nm 3kHz Linewidth PM Fiber Laser Source Benchtop
  
  5:36 AM By MeiLing Chen
  Single frequency narrow linewidth fiber laser adopts rare earth doped fiber DFB laser cavity structure, output single longitudinal mode laser with wavelength of 1550nm, spectral linewidth Read More »